Maytag dishwasher error code F6 E4
The float switch that guards against overfilling has been set off.
We'll check F6 E4 against your exact model, its age and any recalls, and tell you what to do next.
What it usually points to
- A dishwasher that isn't level
You can usually clear it
- Check the dishwasher is level. Whirlpool says a tilt can set the float switch off.
- Cut the power for 30 seconds: unplug the dishwasher, or switch its breaker off if it is wired in.
These are checks you can do without opening the machine up. Don't remove panels, and don't reach inside with the power on. Smell gas, or see smoke or sparks? Stop, leave, and call 911.
The problem behind it
Other Maytag dishwasher codes
F1 E1A fault in the control module.F1 E2The main control has a communication fault.F2 E1A key is stuck, or the console has a fault.F3 E2A fault with the water temperature sensor or the sensor that…F4 E2A fault in the heating system.F6 E1A fault in the control panel or the main control.F6 E3The dishwasher detected too many suds, so it may not fill or…F7 E2A fault with the wash motor.
Meaning read from Maytag product help: dishwasher error codes and written in our own words. Last checked 11 November 2026. Maytag dishwashers are built by Whirlpool and show the same codes. On models without a display, the Clean light flashes the code: count the first set of flashes for the F number, then after a short pause the second set for the E number.