SerialPlate
SerialPlate / Problems / Microwave not heating / Samsung

Samsung microwave not heating

A microwave that runs but does not heat almost always has a failed part inside, and that is a technician's job. Rule out the settings first: demo mode, a low power level, or a door that is not fully shut. On an older countertop model, a new microwave often costs less than the repair.

First: Never take the cover off a microwave. It can hold a dangerous charge even when it is unplugged.

Take a photo of the label

We'll work out which of these fits your exact model, and whether it is safe to fix yourself.

What a Samsung shows for this

If the display shows a code, it narrows the cause down. Samsung uses these 3 codes when a microwave is not heating.

CodeWhat it meansSamsung says
C-20A fault with the temperature sensor.Needs a technician
E-06A fault with the swing heater.Needs a technician
E-21A fault with the temperature sensor, or the microwave got too hot.Needs a technician

Codes differ between models. No code on the display? The checks below still apply.

What to check first

These are in rough order of how often they are the cause. Each can be checked without opening the microwave up.

  1. Demo mode. The light, the turntable and the countdown all work, but nothing warms at all. Common on a new microwave or after a power cut.
    Look up how to turn off demo mode for your model. It is usually a button held for a few seconds, or an entry in the settings menu.
  2. The power level is set low. Food warms a little, slowly.
    Set the power level to 100% or High, then heat a cup of water for one minute. It should be hot.
  3. The kitchen timer, not a cook time. The display counts down and beeps, but the turntable and the light stayed off.
    Press Cancel, then enter the time with Cook Time or the number pad and press Start. The Timer button only counts down.
  4. The door is not shutting fully. It stops and starts, or only heats when you push on the door.
    Wipe the edges of the door and the latch area, and make sure nothing is caught in the door. If the door or its hinges are bent, stop using it.
  5. A weak supply. It runs from an extension lead or a shared power strip, and heats poorly.
    Plug the microwave straight into a wall outlet, with nothing else on that outlet.

What needs a technician

If the checks above change nothing, it is usually one of these. They mean opening the microwave up, which is not a job to do yourself.

Stop and call someone if

Don't remove panels, and don't reach inside with the power on. Smell gas, or see smoke or sparks? Stop, leave, and call 911.

More on Samsung

Other makers

The causes on this page were written with AI from general repair knowledge and have not yet been reviewed by a technician. Code meanings read from Samsung support: what does the error code on my microwave mean? and written in our own words. Last checked 11 November 2026. SerialPlate gives guidance, not a guarantee.