Maytag front-load washer error code INT
The cycle was paused or cancelled, and the washer is still spinning down and draining.
We'll check INT against your exact model, its age and any recalls, and tell you what to do next.
What it usually points to
- A paused or cancelled cycle
Not a fault
- Wait. It can take 20 to 30 minutes.
- To clear it, press Pause or Cancel twice and Power once. If it stays, unplug the washer for five minutes.
These are checks you can do without opening the machine up. Don't remove panels, and don't reach inside with the power on. Smell gas, or see smoke or sparks? Stop, leave, and call 911.
Other Maytag front-load washer codes
LOCControl Lock is switched on.DETThe washer can't find a detergent cartridge in the dispenser.RLThe washer found items in the drum during the Clean Washer c…SUDThere are too many suds for the washer to spin the water out…F5 E2The door isn't locking.F7 E1The motor can't reach the speed the cycle needs.F8 E1The washer senses that water is coming in too slowly.F8 E2There is a problem with the detergent dispenser system.
Meaning read from Maytag product help: error codes in front load washers and written in our own words. Last checked 11 November 2026. Maytag washers are built by Whirlpool and show the same codes. Maytag notes these may not be all the codes your model can show. For any other F and E code, it says to unplug the washer for five minutes and, if the code returns, book service.