SerialPlate
SerialPlate / Error codes / Maytag front-load washer

Maytag front-load washer error codes

10 codes. 6 are ones you can usually clear yourself, and 0 are ones Maytag says need a technician.

Take a photo of the label

Tell us the code and we'll check it against your exact model, its age and any recalls.

CodeWhat it means
LOCControl Lock is switched on.
Not a fault · also shown as LC
DETThe washer can't find a detergent cartridge in the dispenser.
Not a fault
INTThe cycle was paused or cancelled, and the washer is still spinning down and draining.
Not a fault
RLThe washer found items in the drum during the Clean Washer cycle.
Not a fault · also shown as F34
SUDThere are too many suds for the washer to spin the water out, so it is adding rinses to break them down.
You can usually clear it · also shown as SD
F5 E2The door isn't locking.
You can usually clear it
F7 E1The motor can't reach the speed the cycle needs.
You can usually clear it
F8 E1The washer senses that water is coming in too slowly.
You can usually clear it · also shown as LO FL, LF
F8 E2There is a problem with the detergent dispenser system.
You can usually clear it
F9 E1Draining is taking longer than it should, usually more than eight minutes.
You can usually clear it

Worth knowing

Maytag washers are built by Whirlpool and show the same codes. Maytag notes these may not be all the codes your model can show. For any other F and E code, it says to unplug the washer for five minutes and, if the code returns, book service.

Meanings read from Maytag product help: error codes in front load washers and written in our own words. Last checked 11 November 2026. Codes differ between models; your manual lists the ones for yours. Shown as: LOC or LC; DET; INT and so on.