Whirlpool front-load washer error code F8 E1 or LO FL or LF
The washer senses that water is coming in too slowly.
We'll check F8 E1 against your exact model, its age and any recalls, and tell you what to do next.
What it usually points to
- A tap that isn't fully open
- A kinked inlet hose
- An anti-flood device on the water line
You can usually clear it
- Make sure both the hot and cold taps are fully open.
- Check the inlet hoses for kinks.
- Press Pause or Cancel twice and Power once to clear the code.
These are checks you can do without opening the machine up. Don't remove panels, and don't reach inside with the power on. Smell gas, or see smoke or sparks? Stop, leave, and call 911.
Other Whirlpool front-load washer codes
LOCControl Lock is switched on.DETThe washer can't find a detergent cartridge in the dispenser.INTThe cycle was paused or cancelled, and the washer is still s…RLThe washer found items in the drum during the Clean Washer c…SUDThere are too many suds for the washer to spin the water out…F5 E2The door isn't locking.F7 E1The motor can't reach the speed the cycle needs.F8 E2There is a problem with the detergent dispenser system.
Meaning read from Whirlpool product help: error codes in front load washers and written in our own words. Last checked 11 November 2026. Maytag's support site gives the same codes with the same wording. Whirlpool notes these may not be all the codes your model can show. For any other F and E code, it says to unplug the washer for five minutes and, if the code returns, book service.