Maytag dishwasher not draining
A dishwasher that leaves water in the bottom usually has a blocked filter, or a kinked or blocked drain hose. Clean the filter first, then look at the hose under the sink. If both are clear and it still will not drain, the drain pump is the likely cause, and that is a technician's job.
We'll work out which of these fits your exact model, and whether it is safe to fix yourself.
What a Maytag shows for this
If the display shows a code, it narrows the cause down. Maytag uses these 2 codes when a dishwasher is not draining.
| Code | What it means | Maytag says |
|---|---|---|
| F9 E1 | Draining is taking too long, or the dishwasher isn't draining. | You can usually clear it |
| F9 E2 | A fault with the drain motor, or a blocked drain. | You can usually clear it |
Codes differ between models. No code on the display? The checks below still apply.
What to check first
These are in rough order of how often they are the cause. Each can be checked without opening the dishwasher up.
- A blocked filter. Dirty water sits over the filter at the bottom of the tub, and dishes come out gritty.
Take out the bottom rack, lift out the filter the way your manual shows, rinse it under the tap and lock it back in. - A kinked or squashed drain hose. It started after something was moved or stored under the sink.
Look under the sink where the dishwasher's hose joins the drain. Straighten any kink and move anything pressing on it. - A blocked garbage disposal. The hose runs to a disposal, and the sink is slow as well.
Run the disposal with cold water for 30 seconds, then run the dishwasher's drain or cancel cycle. - A blocked air gap. Your sink has a small cylinder beside the tap, and water spills from it when the dishwasher drains.
Lift off the air gap's cap and clear out anything inside. - A blocked sink drain. The sink itself drains slowly or backs up.
Clear the sink's drain first. The dishwasher empties into it, so it cannot drain until the sink can.
What needs a technician
If the checks above change nothing, it is usually one of these. They mean opening the dishwasher up, which is not a job to do yourself.
- A new disposal with its plug still in. The disposal was just replaced and the dishwasher has not drained since.
- A jammed or failed drain pump. At the point it should drain you hear a hum with no water moving, or nothing at all.
- A control or wiring fault. The pump never runs, and a reset at the breaker changes nothing.
Stop and call someone if
- Water is leaking onto the floor: switch off the dishwasher's breaker and close its water supply valve.
- There is water near an outlet or a power cord.
Don't remove panels, and don't reach inside with the power on. Smell gas, or see smoke or sparks? Stop, leave, and call 911.
What is normal
A little clean water under the filter is normal. It keeps the seals from drying out.
More on Maytag
Other makers
Other dishwasher problems
The causes on this page were written with AI from general repair knowledge and have not yet been reviewed by a technician. Code meanings read from Maytag product help: dishwasher error codes and written in our own words. Last checked 11 November 2026. SerialPlate gives guidance, not a guarantee.