SerialPlate
SerialPlate / Problems / Dishwasher not draining / Bosch

Bosch dishwasher not draining

A dishwasher that leaves water in the bottom usually has a blocked filter, or a kinked or blocked drain hose. Clean the filter first, then look at the hose under the sink. If both are clear and it still will not drain, the drain pump is the likely cause, and that is a technician's job.

Take a photo of the label

We'll work out which of these fits your exact model, and whether it is safe to fix yourself.

What a Bosch shows for this

If the display shows a code, it narrows the cause down. Bosch uses these 4 codes when a dishwasher is not draining.

CodeWhat it meansBosch says
E22Water can't get through the filter at the bottom of the tub.You can usually clear it
E23The drain pump is blocked, clogged or has failed.Needs a technician
E24The dishwasher isn't draining.You can usually clear it
E25The drain pump is blocked, or its cover is loose or missing.You can usually clear it

Codes differ between models. No code on the display? The checks below still apply.

What to check first

These are in rough order of how often they are the cause. Each can be checked without opening the dishwasher up.

  1. A blocked filter. Dirty water sits over the filter at the bottom of the tub, and dishes come out gritty.
    Take out the bottom rack, lift out the filter the way your manual shows, rinse it under the tap and lock it back in.
  2. A kinked or squashed drain hose. It started after something was moved or stored under the sink.
    Look under the sink where the dishwasher's hose joins the drain. Straighten any kink and move anything pressing on it.
  3. A blocked garbage disposal. The hose runs to a disposal, and the sink is slow as well.
    Run the disposal with cold water for 30 seconds, then run the dishwasher's drain or cancel cycle.
  4. A blocked air gap. Your sink has a small cylinder beside the tap, and water spills from it when the dishwasher drains.
    Lift off the air gap's cap and clear out anything inside.
  5. A blocked sink drain. The sink itself drains slowly or backs up.
    Clear the sink's drain first. The dishwasher empties into it, so it cannot drain until the sink can.

What needs a technician

If the checks above change nothing, it is usually one of these. They mean opening the dishwasher up, which is not a job to do yourself.

Stop and call someone if

Don't remove panels, and don't reach inside with the power on. Smell gas, or see smoke or sparks? Stop, leave, and call 911.

What is normal

A little clean water under the filter is normal. It keeps the seals from drying out.

More on Bosch

Other makers

Other dishwasher problems

The causes on this page were written with AI from general repair knowledge and have not yet been reviewed by a technician. Code meanings read from Bosch owner support: dishwasher error codes and written in our own words. Last checked 11 November 2026. SerialPlate gives guidance, not a guarantee.