SerialPlate
SerialPlate / Problems / Dishwasher not starting / Frigidaire

Frigidaire dishwasher not starting

A dishwasher that will not start usually has a door that is not latched, the control lock or a delayed start switched on, or no power. Check those, then reset it at the breaker. If the lights work, the door clicks shut and it still will not run, the door latch or the control board has likely failed.

Take a photo of the label

We'll work out which of these fits your exact model, and whether it is safe to fix yourself.

What a Frigidaire shows for this

If the display shows a code, it narrows the cause down. Frigidaire uses this code when a dishwasher is not starting.

CodeWhat it meansFrigidaire says
CLThe door isn't closed and latched.You can usually clear it

Codes differ between models. No code on the display? The checks below still apply.

What to check first

These are in rough order of how often they are the cause. Each can be checked without opening the dishwasher up.

  1. The door is not latched. The lights come on, but nothing happens when you press Start, or it starts and stops straight away.
    Make sure no rack, handle or tall item is in the way, then push the door firmly until it clicks. On many models you press Start first and shut the door within a few seconds.
  2. The control lock is on. A padlock light is lit and the buttons do nothing.
    Hold the lock button for three to four seconds until the padlock light goes out. It is often marked on the Heated Dry or Delay button.
  3. A delayed start is set. The display shows a number of hours, or a Delay light is on.
    Press Cancel or hold Start for three seconds, then start a normal cycle.
  4. No power. No lights at all.
    Check the dishwasher's breaker. Many kitchens also have a wall switch for the dishwasher, often beside the one for the disposal: make sure it is on.
  5. The controls need a reset. Lights flash or the buttons do not respond, often after a power cut.
    Switch the dishwasher's breaker off for one minute, then back on.
  6. The water supply is shut. It starts, hums for a while with no water coming in, and stops.
    Check that the valve on the dishwasher's water line under the sink is fully open.

What needs a technician

If the checks above change nothing, it is usually one of these. They mean opening the dishwasher up, which is not a job to do yourself.

Stop and call someone if

Don't remove panels, and don't reach inside with the power on. Smell gas, or see smoke or sparks? Stop, leave, and call 911.

More on Frigidaire

Other makers

Other dishwasher problems

The causes on this page were written with AI from general repair knowledge and have not yet been reviewed by a technician. Code meanings read from Frigidaire owner support: dishwasher error codes and alarms guide and written in our own words. Last checked 11 November 2026. SerialPlate gives guidance, not a guarantee.