Maytag dishwasher not starting
A dishwasher that will not start usually has a door that is not latched, the control lock or a delayed start switched on, or no power. Check those, then reset it at the breaker. If the lights work, the door clicks shut and it still will not run, the door latch or the control board has likely failed.
We'll work out which of these fits your exact model, and whether it is safe to fix yourself.
What a Maytag shows for this
If the display shows a code, it narrows the cause down. Maytag uses these 2 codes when a dishwasher is not starting.
| Code | What it means | Maytag says |
|---|---|---|
| F1 E2 | The main control has a communication fault. | Needs a technician |
| F2 E1 | A key is stuck, or the console has a fault. | Needs a technician |
Codes differ between models. No code on the display? The checks below still apply.
What to check first
These are in rough order of how often they are the cause. Each can be checked without opening the dishwasher up.
- The door is not latched. The lights come on, but nothing happens when you press Start, or it starts and stops straight away.
Make sure no rack, handle or tall item is in the way, then push the door firmly until it clicks. On many models you press Start first and shut the door within a few seconds. - The control lock is on. A padlock light is lit and the buttons do nothing.
Hold the lock button for three to four seconds until the padlock light goes out. It is often marked on the Heated Dry or Delay button. - A delayed start is set. The display shows a number of hours, or a Delay light is on.
Press Cancel or hold Start for three seconds, then start a normal cycle. - No power. No lights at all.
Check the dishwasher's breaker. Many kitchens also have a wall switch for the dishwasher, often beside the one for the disposal: make sure it is on. - The controls need a reset. Lights flash or the buttons do not respond, often after a power cut.
Switch the dishwasher's breaker off for one minute, then back on. - The water supply is shut. It starts, hums for a while with no water coming in, and stops.
Check that the valve on the dishwasher's water line under the sink is fully open.
What needs a technician
If the checks above change nothing, it is usually one of these. They mean opening the dishwasher up, which is not a job to do yourself.
- A failed door latch or door switch. The door shuts but never clicks, or the dishwasher acts as if it were open.
- A blown thermal fuse. Completely dead with power at the breaker.
- A failed control board or touchpad. Some buttons work and others never do, or it stays dead after a reset.
Stop and call someone if
- You smell burning.
- There is water near an outlet or a power cord.
Don't remove panels, and don't reach inside with the power on. Smell gas, or see smoke or sparks? Stop, leave, and call 911.
More on Maytag
Other makers
Other dishwasher problems
The causes on this page were written with AI from general repair knowledge and have not yet been reviewed by a technician. Code meanings read from Maytag product help: dishwasher error codes and written in our own words. Last checked 11 November 2026. SerialPlate gives guidance, not a guarantee.