SerialPlate
SerialPlate / Problems / Dryer drum not turning

Dryer drum not turning

When a dryer runs but the drum does not turn, the drive belt has usually broken, and that is a technician's job. First make sure it is not just overloaded or on a rack-dry setting. If the drum spins by hand with no resistance at all, the belt has gone. Do not keep running it: the heat stays on with nothing moving.

Take a photo of the label

We'll work out which of these fits your exact model, and whether it is safe to fix yourself.

What to check first

These are in rough order of how often they are the cause. Each can be checked without opening the dryer up.

  1. An overloaded drum. It started with a very heavy, wet load, and the motor hums or strains.
    Take half the load out and start it again.
  2. A rack-dry or no-tumble setting. It began after someone used the drying rack or changed the cycle.
    Make sure Rack Dry or a no-tumble option is off, and take out the drying rack if one is fitted.
  3. Something jammed at the drum's edge. A scraping sound, or the drum moves a little and stops.
    Unplug the dryer. Look around the front edge of the drum for a coin, a wire or a small sock caught in the gap, and lift it out if you can reach it easily.

What needs a technician

If the checks above change nothing, it is usually one of these. They mean opening the dryer up, which is not a job to do yourself.

Stop and call someone if

Don't remove panels, and don't reach inside with the power on. Smell gas, or see smoke or sparks? Stop, leave, and call 911.

What your display may show

Each maker has its own codes for this. Pick yours to see what they mean.

Other dryer problems

The causes on this page were written with AI from general repair knowledge and have not yet been reviewed by a technician. SerialPlate gives guidance, not a guarantee.