LG washer not draining
A washer left full of water usually has a kinked drain hose, a blocked pump filter, or a sock caught in the pump. Check the hose first, then the pump filter on a front-loader. If those are clear and you hear the pump hum without the water moving, the pump has failed.
We'll work out which of these fits your exact model, and whether it is safe to fix yourself.
What a LG shows for this
If the display shows a code, it narrows the cause down. LG uses these 3 codes when a washer is not draining.
| Code | What it means | LG says |
|---|---|---|
| OE | The water can't drain.On a washer | You can usually clear it |
| FF | Water in the washer or its hoses has frozen.On a washer | You can usually clear it |
| OE | The washer can't drain.On a front-load washer | You can usually clear it |
Codes differ between models. No code on the display? The checks below still apply.
What to check first
These are in rough order of how often they are the cause. Each can be checked without opening the washer up.
- A kinked or blocked drain hose. It started after the washer was moved, or the hose is bent sharply behind it.
Look at the drain hose behind the washer. Straighten any kink, and make sure it is pushed only a few inches into the drainpipe, not sealed in with tape. - A blocked pump filter (front-loaders). It drains slowly or not at all, sometimes with a rattle from the bottom front.
Wait until the water is cool. Open the small door at the bottom front, put towels and a shallow tray underneath, unscrew the filter slowly, clear it and screw it back firmly. - Too much detergent. Suds are still visible at the end, or the display shows a suds code.
Run a rinse and spin with no detergent. Use less, and only HE detergent in an HE washer. - An unbalanced load. The load is one heavy item, bunched on one side, and the washer stopped before the final spin.
Spread the load evenly around the drum and run Drain and Spin.
What needs a technician
If the checks above change nothing, it is usually one of these. They mean opening the washer up, which is not a job to do yourself.
- A blocked house drain. Water rises out of the drainpipe or a nearby sink when the washer tries to empty.
- A lid or door lock that has failed. The lock light flashes and the cycle will not go on to drain.
- A jammed or failed drain pump. A hum or a grinding noise with no water moving, or silence where the pump should run.
Stop and call someone if
- Water is on the floor near an outlet or a power cord.
- You smell burning.
Don't remove panels, and don't reach inside with the power on. Smell gas, or see smoke or sparks? Stop, leave, and call 911.
More on LG
Other makers
Other washer problems
The causes on this page were written with AI from general repair knowledge and have not yet been reviewed by a technician. Code meanings read from LG support: washer error code list and LG support: front load washer error code list and written in our own words. Last checked 11 November 2026. SerialPlate gives guidance, not a guarantee.