Frigidaire washer not spinning
A washer that will not spin is usually protecting itself: the load is unbalanced, the water has not drained, or the lid or door is not locking. Spread the load out and run Drain and Spin. If it drains, the door locks and the drum still will not turn, a belt, motor or control part has failed.
We'll work out which of these fits your exact model, and whether it is safe to fix yourself.
What a Frigidaire shows for this
If the display shows a code, it narrows the cause down. Frigidaire uses these 2 codes when a washer is not spinning.
| Code | What it means | Frigidaire says |
|---|---|---|
| E3 | The lid is open, or the lid lock failed. | You can usually clear it |
| E4 | The washer is out of balance during the spin. | You can usually clear it |
Codes differ between models. No code on the display? The checks below still apply.
What to check first
These are in rough order of how often they are the cause. Each can be checked without opening the washer up.
- An unbalanced load. It tries to spin, thumps, stops and tries again. Common with one heavy item such as a rug or a duvet.
Spread the load evenly around the drum, or add a couple of towels to balance a single heavy item. Then run Drain and Spin. - The water has not drained. Water is still in the drum. A washer will not spin while it is full.
Deal with the draining first: check the drain hose for kinks and, on a front-loader, clean the pump filter. - Too many suds. Suds are visible through the door or lid, or the display shows a suds code.
Run a rinse and spin with no detergent. Use less next time. - The washer is not level. It rocks when you push a corner, and walks or bangs in the spin.
Turn the feet until the washer sits firm on all four and does not rock. - A no-spin or delicate setting. Clothes come out wetter than usual on one cycle only.
Check the spin speed is not set to No Spin or Low, and try a Normal cycle. - The lid or door is not locking. The lock light flashes, or you hear the lock click several times.
Open the door or lid, make sure no clothing is caught in it, and close it firmly.
What needs a technician
If the checks above change nothing, it is usually one of these. They mean opening the washer up, which is not a job to do yourself.
- A failed lid or door lock. Nothing is caught, the door is shut, and it still will not lock.
- A worn belt, coupling or clutch. The motor runs but the drum does not turn, or you smell rubber.
- A failed motor or motor control. It drains and locks, then nothing: no hum, no movement.
Stop and call someone if
- You smell burning rubber or see smoke.
- The washer bangs hard enough to move across the floor.
Don't remove panels, and don't reach inside with the power on. Smell gas, or see smoke or sparks? Stop, leave, and call 911.
More on Frigidaire
Other makers
Other washer problems
The causes on this page were written with AI from general repair knowledge and have not yet been reviewed by a technician. Code meanings read from Frigidaire owner support: washer articles and written in our own words. Last checked 11 November 2026. SerialPlate gives guidance, not a guarantee.