SerialPlate
SerialPlate / Error codes / GE top-load washer

GE top-load washer error codes

7 codes. 4 are ones you can usually clear yourself, and 1 are ones GE says need a technician.

Take a photo of the label

Tell us the code and we'll check it against your exact model, its age and any recalls.

CodeWhat it means
H2O SUPPLYWater isn't entering the washer. The Wash and Rinse lights may blink instead.
You can usually clear it · also shown as IE
CAnCELEdThe washer was paused for more than 24 hours, or stopped itself before the cycle finished.
You can usually clear it
LIDThree cycles have been started without the lid being opened, so the washer won't start another.
Not a fault
dEThe lid is open, which pauses the washer.
Not a fault · also shown as E2
UEThe load is unbalanced.
You can usually clear it
FEThe water in the washer has reached a critical level.
Needs a technician
PoThe washer took too long to pump the water out. The Rinse light may flash instead.
You can usually clear it

Worth knowing

These are for washers with electronic controls made in 2017 or later, and messages vary by model. The Po code is from GE's separate page on washers that won't drain, and applies from 2015.

Meanings read from GE Appliances support: washer consumer help indicator and written in our own words. Last checked 11 November 2026. Codes differ between models; your manual lists the ones for yours. Shown as: H2O SUPPLY or IE; CAnCELEd; LID and so on.