GE top-load washer error code H2O SUPPLY or IE
Water isn't entering the washer. The Wash and Rinse lights may blink instead.
We'll check H2O SUPPLY against your exact model, its age and any recalls, and tell you what to do next.
What it usually points to
- Closed water supply valves
- A water supply problem in the house
You can usually clear it
- Check the house water is on and the supply valves behind the washer are open.
- The controls lock for four minutes. Wait, then start the cycle again. Unplugging restarts the four minutes.
These are checks you can do without opening the machine up. Don't remove panels, and don't reach inside with the power on. Smell gas, or see smoke or sparks? Stop, leave, and call 911.
Other GE top-load washer codes
CAnCELEdThe washer was paused for more than 24 hours, or stopped its…LIDThree cycles have been started without the lid being opened,…dEThe lid is open, which pauses the washer.UEThe load is unbalanced.FEThe water in the washer has reached a critical level.PoThe washer took too long to pump the water out. The Rinse li…
Meaning read from GE Appliances support: washer consumer help indicator and written in our own words. Last checked 11 November 2026. These are for washers with electronic controls made in 2017 or later, and messages vary by model. The Po code is from GE's separate page on washers that won't drain, and applies from 2015.