Whirlpool dishwasher error code F6 E3
The dishwasher detected too many suds, so it may not fill or wash properly.
We'll check F6 E3 against your exact model, its age and any recalls, and tell you what to do next.
What it usually points to
- Hand dish soap, laundry detergent or another wrong detergent
- The rinse aid cap left off
- Too much detergent
You can usually clear it
- Scoop the suds out with a plastic cup.
- Take the dishes out and add two to three tablespoons of vegetable oil to the bottom of the tub.
- Run a full cycle with no detergent and no dishes, then another with detergent and no dishes.
These are checks you can do without opening the machine up. Don't remove panels, and don't reach inside with the power on. Smell gas, or see smoke or sparks? Stop, leave, and call 911.
Other Whirlpool dishwasher codes
F1 E1A fault in the control module.F1 E2The main control has a communication fault.F2 E1A key is stuck, or the console has a fault.F3 E2A fault with the water temperature sensor or the sensor that…F4 E2A fault in the heating system.F6 E1A fault in the control panel or the main control.F6 E4The float switch that guards against overfilling has been se…F7 E2A fault with the wash motor.
Meaning read from Whirlpool product help: dishwasher error codes and written in our own words. Last checked 11 November 2026. KitchenAid's support site gives the same codes with the same meanings. On models without a display, the Clean light flashes the code: count the first set of flashes for the F number, then after a short pause the second set for the E number.