Whirlpool dishwasher leaking
A dishwasher that leaks from the door usually has the wrong detergent or too much of it, a dirty door seal, or something sticking out past the rack. Water from underneath usually means a hose, the pump or the inlet valve, and that needs a technician. If water is reaching the floor, switch the dishwasher off at the breaker and close its water valve.
First: If water is near an outlet or a power cord, do not step in it. Switch off the dishwasher's breaker first.
We'll work out which of these fits your exact model, and whether it is safe to fix yourself.
What a Whirlpool shows for this
If the display shows a code, it narrows the cause down. Whirlpool uses these 2 codes when a dishwasher is leaking.
| Code | What it means | Whirlpool says |
|---|---|---|
| F6 E4 | The float switch that guards against overfilling has been set off. | You can usually clear it |
| F8 E4 | Water was detected in the tray under the dishwasher. It starts draining and won't run. | Needs a technician |
Codes differ between models. No code on the display? The checks below still apply.
What to check first
These are in rough order of how often they are the cause. Each can be checked without opening the dishwasher up.
- The wrong detergent, or too much. Foam at the bottom of the door. It often follows using washing-up liquid.
Let the foam settle, wipe out what you can, and run a rinse cycle with no detergent. Use only dishwasher detergent, and less of it in soft water. - A dirty door seal. Drips from the bottom corners of the door, and grime on the rubber seal.
Wipe the rubber seal and the edge of the door it presses on with a damp cloth, including the bottom lip. - Something blocking the door or the spray. It leaks only on some loads.
Make sure the racks are pushed fully in, nothing sticks out past them, and no tall item stops the spray arms turning. - The rinse aid cap is loose or overfilled. Foam with a blue or clear slick, and streaks on the door.
Wipe up any spilled rinse aid and close the cap until it clicks.
What needs a technician
If the checks above change nothing, it is usually one of these. They mean opening the dishwasher up, which is not a job to do yourself.
- The dishwasher is not level. It leaks from one front corner, often after new flooring or a new worktop.
- A worn or torn door seal. The seal is flattened, split or pulling out of its groove.
- A leaking hose, pump or inlet valve. Water appears underneath, not at the door, sometimes when the dishwasher is not even running.
- It is overfilling. Water sits high in the tub before it leaks, or the dishwasher keeps draining on its own.
Stop and call someone if
- Water is near an outlet or a power cord.
- Water is coming through to the room below.
- It leaks with the dishwasher switched off: close the valve on its water line.
Don't remove panels, and don't reach inside with the power on. Smell gas, or see smoke or sparks? Stop, leave, and call 911.
More on Whirlpool
Other makers
Other dishwasher problems
The causes on this page were written with AI from general repair knowledge and have not yet been reviewed by a technician. Code meanings read from Whirlpool product help: dishwasher error codes and written in our own words. Last checked 11 November 2026. SerialPlate gives guidance, not a guarantee.