SerialPlate
SerialPlate / Problems / Dryer not heating / Samsung

Samsung dryer not heating

A dryer that tumbles but stays cold usually has a blocked vent, a half-tripped breaker on an electric model, or no gas reaching a gas model. Check the breaker, the lint screen and the vent outside first. If those are fine, a part inside has failed, most often the thermal fuse or the heating element, and that is a technician's job.

First: If you smell gas, stop. Leave the house and call your gas company or 911 from outside.

Take a photo of the label

We'll work out which of these fits your exact model, and whether it is safe to fix yourself.

What a Samsung shows for this

If the display shows a code, it narrows the cause down. Samsung uses these 6 codes when a dryer is not heating.

CodeWhat it meansSamsung says
tSThere is a problem with the temperature inside the dryer or the sensor that measures it.You can usually clear it
HCThe dryer is getting too hot. Less often, the heater isn't getting hot enough.You can usually clear it
ClgAfter a Vent Blockage test: the vent is clogged.You can usually clear it
C80After a Vent Blockage test: the vent is about 80% clogged.You can usually clear it
C90After a Vent Blockage test: the vent is more than 90% clogged.You can usually clear it
HC2On a gas dryer, the flame didn't light.Needs a technician

Codes differ between models. No code on the display? The checks below still apply.

What to check first

These are in rough order of how often they are the cause. Each can be checked without opening the dryer up.

  1. A half-tripped breaker (electric dryers). The drum turns and the light works, but there is no heat at all.
    An electric dryer runs on two breakers joined together. If one trips, the drum still turns. Switch the dryer's breaker fully off, then back on.
  2. A clogged lint screen. Clothes take longer and longer to dry, and the screen looks clean but water pools on it.
    Clean the lint screen. If water sits on it instead of running through, wash it with warm soapy water and let it dry.
  3. A blocked vent. The dryer and the clothes get hot but stay damp, or the dryer cuts out. Little or no air comes out of the vent outside.
    Go outside while the dryer runs. The vent flap should open and blow warm air. Clear any lint from the flap.
  4. A no-heat setting. It started after someone changed the cycle.
    Make sure the cycle is not Air Fluff or Air Dry, and that Eco or Energy Saver is off. Run a timed cycle on high heat to test.

What needs a technician

If the checks above change nothing, it is usually one of these. They mean opening the dryer up, which is not a job to do yourself.

Stop and call someone if

Don't remove panels, and don't reach inside with the power on. Smell gas, or see smoke or sparks? Stop, leave, and call 911.

More on Samsung

Other makers

Other dryer problems

The causes on this page were written with AI from general repair knowledge and have not yet been reviewed by a technician. Code meanings read from Samsung support: dryer displays an error code and written in our own words. Last checked 11 November 2026. SerialPlate gives guidance, not a guarantee.