Bosch washer error code E:30 -10
The washer isn't getting the water it expects. The tap symbol may show too.
We'll check E:30 -10 against your exact model, its age and any recalls, and tell you what to do next.
What it usually points to
- A closed tap
- A kinked inlet hose
- Low water pressure or blocked inlet filters
- A fault in the water-level measuring system
You can usually clear it
- Make sure the tap is on and the inlet hose isn't kinked.
- Wait about five minutes for draining to finish, switch the washer off to reset it, then on.
These are checks you can do without opening the machine up. Don't remove panels, and don't reach inside with the power on. Smell gas, or see smoke or sparks? Stop, leave, and call 911.
Other Bosch washer codes
CLChild Lock is on.E:00 -18The drain pump is blocked.E:00 -23There is water in the base of the washer, or the washer is l…E:10 -00The pump for the automatic detergent dosing system is blocked.E16The door isn't locked properly.E17Water isn't coming in properly: the inlet filters are blocke…E18The drain hose is blocked or kinked.E:30 -20The water level is higher than expected.
Meaning read from Bosch owner support: washer error codes and written in our own words. Last checked 11 November 2026. Newer displays show two parts that alternate, such as E:36 and -10. For any code not listed, Bosch says to switch the washer off and on, then unplug it for 30 seconds, and call if it returns.