Whirlpool dishwasher error code F9 E1
Draining is taking too long, or the dishwasher isn't draining.
We'll check F9 E1 against your exact model, its age and any recalls, and tell you what to do next.
What it usually points to
- A clogged filter
- A kinked or clogged drain hose
- A clogged garbage disposal or air gap
You can usually clear it
- Take out the filter at the bottom of the tub and wash it under running water.
- Check the drain hose under the sink for kinks, pinches or clogs.
- Run the garbage disposal to clear it. If the disposal is new, check its knockout plug was removed.
- If there is an air gap on the sink, take off its cap and clear it.
- Cut the power for 30 seconds: unplug the dishwasher, or switch its breaker off if it is wired in.
These are checks you can do without opening the machine up. Don't remove panels, and don't reach inside with the power on. Smell gas, or see smoke or sparks? Stop, leave, and call 911.
The problem behind it
Other Whirlpool dishwasher codes
F1 E1A fault in the control module.F1 E2The main control has a communication fault.F2 E1A key is stuck, or the console has a fault.F3 E2A fault with the water temperature sensor or the sensor that…F4 E2A fault in the heating system.F6 E1A fault in the control panel or the main control.F6 E3The dishwasher detected too many suds, so it may not fill or…F6 E4The float switch that guards against overfilling has been se…
Meaning read from Whirlpool product help: dishwasher error codes and written in our own words. Last checked 11 November 2026. KitchenAid's support site gives the same codes with the same meanings. On models without a display, the Clean light flashes the code: count the first set of flashes for the F number, then after a short pause the second set for the E number.