SerialPlate
SerialPlate / Error codes / Electrolux front-load washer

Electrolux front-load washer error codes

8 codes. 7 are ones you can usually clear yourself, and 0 are ones Electrolux says need a technician.

Take a photo of the label

Tell us the code and we'll check it against your exact model, its age and any recalls.

CodeWhat it means
E11The washer isn't taking in water during the wash.
You can usually clear it
E21The washer is draining too slowly.
You can usually clear it
E35The pressure sensor says there is too much water in the washer.
You can usually clear it
E41The control thinks the door is open.
You can usually clear it
E42The door lock isn't being detected.
You can usually clear it
HO SEThe hot and cold inlet hoses are connected the wrong way round. The display shows HO, then SE.
You can usually clear it
LOCControl Lock is on, so cycles won't start.
Not a fault
SU dSThe washer detected too many suds and is adding rinses of about five minutes each until they clear.
You can usually clear it

Worth knowing

Electrolux has a separate article for each code. If the washer was installed or moved in the last 30 days, it says to go back to the installer first.

Meanings read from Electrolux owner support: washer articles and written in our own words. Last checked 11 November 2026. Codes differ between models; your manual lists the ones for yours. Shown as: E11; E21; E35 and so on.