SerialPlate
SerialPlate / Problems / Dryer not starting / LG

LG dryer not starting

A dryer that will not start usually has no power, a door that is not fully shut, or the control lock on. Check the breaker, the door and the lock, and hold Start for a few seconds. If the display lights but nothing happens, or you only hear a hum, the door switch, thermal fuse, belt or motor has failed and it needs a technician.

First: If you smell gas, stop. Leave the house and call your gas company or 911 from outside.

Take a photo of the label

We'll work out which of these fits your exact model, and whether it is safe to fix yourself.

What a LG shows for this

If the display shows a code, it narrows the cause down. LG uses these 7 codes when a dryer is not starting.

CodeWhat it meansLG says
LE1The drum isn't turning.You can usually clear it
LE3There is a problem with the motor that moves air through the dryer.Needs a technician
IFThere is a problem with the lint filter.You can usually clear it
PSThe voltage at the power cord is wrong, possibly because two wires were swapped when the cord was fitted.Needs a technician
dEThe door isn't completely closed.You can usually clear it
FOThe lint filter isn't in properly, so the dryer has stopped. The display may also flash INSERT FILTER.You can usually clear it
bEA problem with the drum's drive belt has stopped the drum turning.Needs a technician

Codes differ between models. No code on the display? The checks below still apply.

What to check first

These are in rough order of how often they are the cause. Each can be checked without opening the dryer up.

  1. No power. No lights, no sound.
    Check the dryer's breaker. An electric dryer has two joined together: switch them fully off, then back on. Make sure the plug is pushed in.
  2. The door is not fully shut. The drum light stays on, or the display shows a door message.
    Clear any lint or clothing from around the door catch and close the door firmly.
  3. The control lock is on. A padlock light is lit, or the display shows CL or LOC, and the buttons do nothing.
    Hold the lock button for three seconds until the light goes out. It is usually marked under one of the option buttons.
  4. Start was not held long enough. Everything lights up, and pressing Start does nothing.
    Press and hold Start for three full seconds. Many dryers need a hold, not a tap.
  5. The lint filter is missing. The display shows a filter message. Some dryers will not run without it.
    Push the lint filter all the way in.
  6. A delayed start is set. The display shows a number of hours counting down.
    Press Cancel or turn the dial to Off, then choose a cycle and press Start.

What needs a technician

If the checks above change nothing, it is usually one of these. They mean opening the dryer up, which is not a job to do yourself.

Stop and call someone if

Don't remove panels, and don't reach inside with the power on. Smell gas, or see smoke or sparks? Stop, leave, and call 911.

More on LG

Other makers

Other dryer problems

The causes on this page were written with AI from general repair knowledge and have not yet been reviewed by a technician. Code meanings read from LG support: dryer error code list and written in our own words. Last checked 11 November 2026. SerialPlate gives guidance, not a guarantee.