Samsung dryer not starting
A dryer that will not start usually has no power, a door that is not fully shut, or the control lock on. Check the breaker, the door and the lock, and hold Start for a few seconds. If the display lights but nothing happens, or you only hear a hum, the door switch, thermal fuse, belt or motor has failed and it needs a technician.
First: If you smell gas, stop. Leave the house and call your gas company or 911 from outside.
We'll work out which of these fits your exact model, and whether it is safe to fix yourself.
What a Samsung shows for this
If the display shows a code, it narrows the cause down. Samsung uses these 5 codes when a dryer is not starting.
| Code | What it means | Samsung says |
|---|---|---|
| 9C1 | The voltage reaching the dryer isn't what it expects. | You can usually clear it |
| bE | The dryer thinks a button on the panel is stuck or being held down. | You can usually clear it |
| dC | There is a problem with the door, its latch, or the sensor that checks it is shut. | You can usually clear it |
| FC | The frequency of the power supply isn't valid. | Needs a technician |
| 3C | The dryer has found a fault with its motor. | Needs a technician |
Codes differ between models. No code on the display? The checks below still apply.
What to check first
These are in rough order of how often they are the cause. Each can be checked without opening the dryer up.
- No power. No lights, no sound.
Check the dryer's breaker. An electric dryer has two joined together: switch them fully off, then back on. Make sure the plug is pushed in. - The door is not fully shut. The drum light stays on, or the display shows a door message.
Clear any lint or clothing from around the door catch and close the door firmly. - The control lock is on. A padlock light is lit, or the display shows CL or LOC, and the buttons do nothing.
Hold the lock button for three seconds until the light goes out. It is usually marked under one of the option buttons. - Start was not held long enough. Everything lights up, and pressing Start does nothing.
Press and hold Start for three full seconds. Many dryers need a hold, not a tap. - The lint filter is missing. The display shows a filter message. Some dryers will not run without it.
Push the lint filter all the way in. - A delayed start is set. The display shows a number of hours counting down.
Press Cancel or turn the dial to Off, then choose a cycle and press Start.
What needs a technician
If the checks above change nothing, it is usually one of these. They mean opening the dryer up, which is not a job to do yourself.
- A failed door switch. The door shuts with no click, or the drum light never goes out.
- A blown thermal fuse. It has power and a lit display but is otherwise dead. A blocked vent is the usual cause.
- A broken belt. The drum spins very freely by hand. Many dryers will not start once the belt has gone.
- A failed start switch or motor. A hum or a click when you press Start, and nothing turns.
Stop and call someone if
- You smell gas or burning.
- The plug, cord or outlet is hot or discoloured.
Don't remove panels, and don't reach inside with the power on. Smell gas, or see smoke or sparks? Stop, leave, and call 911.
More on Samsung
Other makers
Other dryer problems
The causes on this page were written with AI from general repair knowledge and have not yet been reviewed by a technician. Code meanings read from Samsung support: dryer displays an error code and written in our own words. Last checked 11 November 2026. SerialPlate gives guidance, not a guarantee.