SerialPlate
SerialPlate / Problems / Dryer not starting / Whirlpool

Whirlpool dryer not starting

A dryer that will not start usually has no power, a door that is not fully shut, or the control lock on. Check the breaker, the door and the lock, and hold Start for a few seconds. If the display lights but nothing happens, or you only hear a hum, the door switch, thermal fuse, belt or motor has failed and it needs a technician.

First: If you smell gas, stop. Leave the house and call your gas company or 911 from outside.

Take a photo of the label

We'll work out which of these fits your exact model, and whether it is safe to fix yourself.

What a Whirlpool shows for this

If the display shows a code, it narrows the cause down. Whirlpool uses these 5 codes when a dryer is not starting.

CodeWhat it meansWhirlpool says
ERRThe door isn't completely closed and latched, so the dryer won't run. It can look shut without being latched.You can usually clear it
F2 E1A fault in the keypad.Needs a technician
F2 E2A fault in the keypad or the control.Needs a technician
F6 E1The main control board and the touch panel have stopped communicating.Needs a technician
F7 E1There may be a problem with the motor, its control or the wiring.Needs a technician

Codes differ between models. No code on the display? The checks below still apply.

What to check first

These are in rough order of how often they are the cause. Each can be checked without opening the dryer up.

  1. No power. No lights, no sound.
    Check the dryer's breaker. An electric dryer has two joined together: switch them fully off, then back on. Make sure the plug is pushed in.
  2. The door is not fully shut. The drum light stays on, or the display shows a door message.
    Clear any lint or clothing from around the door catch and close the door firmly.
  3. The control lock is on. A padlock light is lit, or the display shows CL or LOC, and the buttons do nothing.
    Hold the lock button for three seconds until the light goes out. It is usually marked under one of the option buttons.
  4. Start was not held long enough. Everything lights up, and pressing Start does nothing.
    Press and hold Start for three full seconds. Many dryers need a hold, not a tap.
  5. The lint filter is missing. The display shows a filter message. Some dryers will not run without it.
    Push the lint filter all the way in.
  6. A delayed start is set. The display shows a number of hours counting down.
    Press Cancel or turn the dial to Off, then choose a cycle and press Start.

What needs a technician

If the checks above change nothing, it is usually one of these. They mean opening the dryer up, which is not a job to do yourself.

Stop and call someone if

Don't remove panels, and don't reach inside with the power on. Smell gas, or see smoke or sparks? Stop, leave, and call 911.

More on Whirlpool

Other makers

Other dryer problems

The causes on this page were written with AI from general repair knowledge and have not yet been reviewed by a technician. Code meanings read from Whirlpool product help: dryer error codes and written in our own words. Last checked 11 November 2026. SerialPlate gives guidance, not a guarantee.